Boiler Installation Glossary

Plain-English definitions of key boiler installation terms, components and Irish standards.

Free, no obligation. One registered engineer prices it, not five.

Boiler Installation terms explained in plain English

Definitions of the technical terms, parts and standards that come up on quotes and service sheets.

Like-for-like swap
A new boiler of the same type going on the same spot as the old one, using the same flue position, gas pipe and water connections. The quickest kind of installation and the lowest price, usually one day.
Combi boiler
A boiler that heats the radiators and gives hot water straight from the mains, with no hot water cylinder and no cold tank in the attic.
System boiler
A boiler with the pump and expansion vessel built in, heating the radiators and a sealed hot water cylinder in the hot press. Suits homes where two showers run at once.
Regular (heat-only) boiler
The older layout: a boiler, a cold water tank in the attic, a small feed tank and a cylinder in the hot press. Many Dublin homes built before the 1990s still have one.
kW output
The boiler's heating power. Most apartments need 24 to 25 kW, most 3-bed semis 28 to 30 kW, bigger houses 35 kW or more. Too small and the hot water runs weak, too big and the boiler cycles on and off.
Flue
The pipe that takes the boiler's exhaust gases outside. A new boiler usually uses a horizontal flue straight through the wall behind it, or a vertical flue up through the roof.
Condensate pipe
The plastic pipe that drains the small amount of water a condensing boiler makes. Run outside, it needs to be wide and insulated so it doesn't freeze in a hard frost.
Magnetic filter
A canister on the return pipe under the boiler that catches the black iron sludge that builds up in radiators. Most manufacturers ask for one to honour the warranty.
Power flush
Pumping cleaning chemicals through the radiators at high flow to clear sludge before a new boiler goes on an old system.
Inhibitor
A chemical added to the heating water after the system is filled, to slow down rust inside the radiators and the new boiler.
Commissioning
The installer's checks when the boiler first runs: gas pressure, flue gas reading, controls and safety devices. The readings go on the commissioning record that comes with the boiler.
Declaration of Conformance (Cert 2)
The certificate a Registered Gas Installer must give you after installing or replacing a gas boiler. Keep it with the house papers: a buyer's solicitor will ask for it.

Get a price for your boiler installation

Three taps about the job. One Registered Gas Installer who covers your area rings you with a fixed price.

What's the installation?

Pick the closest. The installer asks about the rest.

Every guide, calculator and county page

Jump straight to any specification guide, our interactive calculator, the technical glossary or your county page.

Get a price for a boiler installation in Dublin

One registered engineer rings you. Free, no obligation.